New machine integration
Agree space, ports, electrical interfaces and the motion sequence during machine design, integrating energy-saving holding into the platform.
APPLICATION SOLUTION
Mold clamping power packs. Run the motor on demand.
Close and clamp the mould, hold pressure, then release for opening and part removal.
Discuss my application ↗INTERMITTENT PRESSURE HOLDING
Short motions. Long holds. Recharge on demand.
Our intermittent-holding solution combines a standard motor, PLC pressure feedback and an accumulator. After clamping, the accumulator supports pressure while the motor runs only when needed—especially suited to long holding phases.- 01
Build pressure
A standard three-phase induction motor drives the pump to establish the pressure required for the motion.
- 02
Hold with the motor stopped
During the holding phase, the motor stops and an accumulator supports pressure holding.
- 03
Recharge on demand
A programmable logic controller (PLC) reads the pressure signal, restarts the motor below a set threshold and stops it at the set pressure.
ENGINEERING INPUTS
Start with these three inputs.
- 01
Clamping pressure, hold duration and motion flow
- 02
Ambient heat, dust, oil temperature and protection
- 03
Connections, maintenance window and machine control signals
Existing machine retrofit
Record current energy and cycle time, inspect cylinders, valves and pipework, then agree retained components, retrofit scope and downtime.
RELATED CUSTOMER STORY
Low-pressure casting mould clamping
Project duty: 100–140 s holding time; 6.3 MPa system pressure.
Review ambient conditions, cooling and protection separately. This case pressure exceeds the 4.5 MPa SC-QT table rating and does not establish a direct replacement with those configurations.
Explore the customer case and results →CHOOSE YOUR SERIES
Find the series for your machine.
SC-QT
0.75 kW; 16 L/min; 20 L tank
1–3 stations; rated pressure 4.5 MPa
Explore configurations →SC-QT
1.5 kW; 20 L/min; 40 L tank
1–6 stations; rated pressure 4.5 MPa
Explore configurations →QZB
Share air supply, output pressure and oil volume per cycle
Request the specifications for your duty
Explore configurations →FROM SELECTION TO DELIVERY
Plan the purchase. Prepare the installation.
- Power & controls
- The catalogue lists AC380V motors and DC24V controls. Share the destination voltage and frequency to confirm the electrical package.
- Dimensions & connections
- Share available space, port orientation, fitting standard and machine control signals. We provide drawings for the selected configuration.
- Quantity & timing
- Tell us whether you need a demonstration unit or a production batch, the quantity and target arrival date. We will prepare the quotation and production/shipping plan.
- Packing & documents
- Agree transport, packing and the packing list before dispatch. The supply package defines the operating instructions, electrical drawings and factory documents.
- Installation & service
- Our engineers assist with wiring, pressure adjustment and troubleshooting. Warranty duration and service terms are confirmed with the supply proposal for the selected model.
ENERGY INTO VALUE
Less idle running. More value.
Make each holding phase count. Stop the motor after motion, then recharge when pressure reaches the set threshold, reducing energy use and heat from continuous idle running.
Save 75% or more in short-motion, long-hold applications. Turn reduced electricity use into lower running costs and get more value from every clamping cycle.
Annual electricity cost savingkWh avoided × electricity tariff
Review the savings potential of your machine →Casting fixture hydraulics: define each phase
A hydraulic power unit for mold clamping must support the closing, clamping, holding and opening sequence. For casting pressure holding, record temperature, pressure, allowable drop and cooling conditions. Compare the required duty with the selected model rating; the higher-pressure casting case is not evidence of a direct replacement by a standard catalogue unit.